Last updated:
09-JAN-2017

Cisco DX70 and DX80 Setup Instructions

The steps below detail how to initialize, provision, and setup the Cisco DX70 and DX80 devices.

Provisioning

  1. Connect your DX70/80 to your Cisco dCloud router.
  2. The device will auto register with Communications Manager with a temporary (11XX) extension.
  3. Dial 1111 on the device to enter the Self-Provisioning IVR.
  4. Press XXXX# on the IP phone, where XXXX is the four-digit extension number of the user for whom you are provisioning this device.
  5. The IVR confirms the self-provisioning was successful and that the phone will reset and provision.

 

Email Setup

  1. On the DX70/80 device, press Settings > Accounts > Add Account.
  2. To set up the demonstration email account for the user, choose Corporate.
  3. Enter the email ID and password for your specific demonstration user, and then press Next. Email address must end in ***@dcloud.cisco.com.
  4. Enter the domain name and password for the user. Domain name must be: dcloud\***username***
  5. Enter the mail server as mail1.dcloud.cisco.com
  6. Click the check mark for Use secure connection (SSL) and Accept all SSL certificates.
  7. Leave the port number as 443 and choose Next.
  8. The new email account is added to the device. Go back to Settings & Accounts, you should see a new account called Corporate.
  9. You can click on the account to synchronize all emails, calendar events, and contacts or you can choose individually which ones to synchronize.

 

Cisco Jabber Setup

  1. Go to Apps on the DX70/80 device and choose Jabber.
  2. In the Jabber app, accept all terms and conditions, and then press Continue.
  3. For the account type information, choose CUCM IM and Presence.
  4. Enter the username and password for the demonstration user to whom you are assigning this device.
  5. Click Continue to accept any certificate warnings.

 

Cisco WebEx Setup

  1. On the DX70/80 device, press Settings > Accounts > Add Account.
  2. Choose the WebEx option.
  3. Enter the email ID and password for your specific demonstration user, and then press Next. Email address must end in ***@dcloud.cisco.com.
  4. You will be signed in to us-gcd.webex.com.

 

Device Wireless and VPN Setup

If you wish to use the DX70/80 device without connecting to a dCloud router, you can enable the wireless network and establish a VPN to the dCloud demonstration.

  1. Disconnect the ethernet cable.
  2. On the DX70/80 device, press Settings, and then enable Wi-Fi on the device.
  3. After turning on Wi-Fi, it shows all available wireless networks. Choose your network and connect to it.
  4. Once you are connected to Wi-Fi, press Settings > More > VPN.
  5. Add the following VPN Profile:
    1. Description: RTP dCloud VPN
    2. Server Address: Use the following based on your datacenter:
      1. APJ – dcloud-sng-anyconnect.cisco.com
      2. EMEAR – dcloud-lon-anyconnect.cisco.com
      3. GC – dcloud-chi-anyconnect.cisco.com
      4. US East – dcloud-rtp-anyconnect.cisco.com
      5. US West – dcloud-sjc-anyconnect.cisco.com
  6. Choose the connection added above and it will prompt you for the username and password. Get these credentials from your demonstration and add them here. [Show Me How]
  7. Accept all security warnings. You are now connected by VPN to the demonstration. Your Phone, Jabber, and Email services can be configured as described above or if they are already created, those services will restart automatically.